Now made by Drake! Our NEW Kick Panels feature Scott Drake’s
top-of-the-line attention to detail, and are available at a
lower price than before! Features include correct flexible
material with factory whole locations, correct flared edge to
accommodate windlace, and concours correct thickness and
texture. New panels are only available in black.
The Scott Drake Panel has
the same contour as the original allowing room for Windlace. The
reproduction panel is flat.
The Scott Drake Pinch Weld Gap (left) is wider, top to bottom
for a much easier installation. Also, includes correct flared
top for proper fitment of Windlace. Our panels snap into place
in seconds, just like originals.
The Scott Drake Panel is molded the same as the original. In
addition, the Scott Drake panel is the correct height and is
flexible. The reproduction panel is taller and rigid which
results in an improper fit.
The Scott Drake Panel has the correct bulge like the original
and the Windlace fits perfectly.
The Scott Drake Panel has factory holes with reinforced Bosses –
just like the originals. As shown on the left, these holes are
molded not drilled. This substantially reduces the time needed
for a proper installation.
The Reproduction Kick Panel has a much smaller bulge that will
not allow Windlace to fit inside Kick Panel as factory intended.
The Reproduction does not have factory holes molded in place
making proper installation extremely difficult. Drilling holes
greatly increases installation time and leaves room for possible
damage to kick panel.
Molded in the same textured plastic as
the originals. The finest available anywhere.